Common failures of screw compressors

Overview

This guide covers Air Compressor and the key points to consider before choosing equipment. There are three common faults of screw compressors: motor overload, high temperature, gas-guzzling. 1.Main reasons of motor overload are as follows: Three filters (air intake filters, oil filters, oil separator) severe blockage; minimum pressure valve seal failure, resulting in a load when the motor starts encounter; when starting, vent valve is not open, the intake valve is not closed. 2.Two

Key Details

main reasons lead to high temperature: Oil filter clogged, thermostatic valve spool jams, internal or external oil cooler is seriously polluted. Oil filter and oil cooler mounted thermostatic valve upstream of the oil is an effective way to avoid failure, but most brands of screw air compressors ‘s oil filter only be protected for air end. Thermostatic valve is mixed by cold oil with hot oil. In any part of the heat will allow the temperature of the refrigeration oil mixed with the oil, so greatly reducing the efficiency of the cooling system. Fan thermostat higher than with a start-stop

Practical Points

reliability and efficiency thermostatic temperature control system. 3.High fuel consumption: Return pipe clogged oil core rupture, low exhaust pressure for a long time. First, check the occurrence of gas-guzzling tank pressure is stable in the vicinity of ratings; Second, check the return pipe temperature is normal, low temperature shows the oil return orifice blockage, is off the main pollutants from the oil tank on the oxide.

What This Means for Buyers

Air quality matters as much as air quantity. Contaminants such as water, oil aerosols and particles can damage tools, spoil product and shorten downstream equipment life. The required purity level depends on the process, from general plant air to strict food and pharmaceutical standards. Operators should record pressure, temperature and running hours daily. A small change in these readings often signals an issue before a failure occurs, which is cheaper to fix than an emergency repair.

How to Select the Right Equipment

Start with the actual air demand. Record the required flow, working pressure, voltage, ambient conditions and duty cycle, then add a safety margin. Match the compressor type to the application. A variable speed drive machine suits changing demand, while a fixed speed machine suits steady full load. For clean processes, an oil free unit or proper filtration is required.

Common Mistakes to Avoid

  • Sizing a compressor from the motor nameplate instead of measured flow.
  • Ignoring air quality and allowing water or oil into the system.
  • Skipping preventive maintenance and waiting for a breakdown.
  • Choosing the lowest price without comparing lifecycle energy cost.

Maintenance and Reliability

A routine service plan keeps output stable and protects the airend, motor and controls. Drain condensate, change filters on schedule, check belts and couplings, and inspect for leaks. A well maintained compressor holds its efficiency and avoids costly unplanned stops.

Next Steps

For help selecting or sizing a system, review the Air Treatment and Screw Air Compressor, or contact AeroWolf with your flow, pressure and air quality requirements.

A clear specification avoids expensive rework. Document the air quality class, the peak and average flow, the pressure band, the power supply and the expected operating hours before asking for a quote.

Compressed air is one of the most common utilities in a factory, yet it is often the least audited. A pressure of 0.1 bar above the requirement already adds measurable energy cost across a full year of operation.

Leakage is a hidden cost. Even a small leak wastes air around the clock. A regular walk through inspection with an ultrasonic detector finds leaks early and pays for itself quickly.

WhatsApp Email Phone