Air compressor regular maintenance – lubricating oil

Overview

For AeroWolf oil-injected type air compressor , once running time reach 500 hours, need to replace the lubricating oil. Following are some notes when doing the maintenance: 1.Usually, we suggest to use the Semi-synthetic type lubricating oil, 46#. 2.For a new air compressor, you should take all oil out of oil gas tank, air end and oil cooler first, then

Key Details

add the new oil into the tank, must make sure the oil level is close or atop of the red line on oil Level Indicator which is mounted outside the tank. 3.For the machine that has already operating, after check the oil is not enough, please kindly add the oil between the two red lines, then it’s enough. 4.During the air compressor loading, the oil level might drop below the red line, this is the common sign, no need worry about that. When the machine stopped, the oil level will return to the middle of two red lines spontaneously. 5.Note:

Practical Points

Two different type lubrication oil can not mix together, will effect the machine usage and service life. Replace the lubricating oil as our Maintenance Schedule is very necessary, once the oil become worse, the lubricating system will surely effected, and oil content of compressed air will be much higher.

What This Means for Buyers

Air quality matters as much as air quantity. Contaminants such as water, oil aerosols and particles can damage tools, spoil product and shorten downstream equipment life. The required purity level depends on the process, from general plant air to strict food and pharmaceutical standards. Operators should record pressure, temperature and running hours daily. A small change in these readings often signals an issue before a failure occurs, which is cheaper to fix than an emergency repair.

How to Select the Right Equipment

Start with the actual air demand. Record the required flow, working pressure, voltage, ambient conditions and duty cycle, then add a safety margin. Match the compressor type to the application. A variable speed drive machine suits changing demand, while a fixed speed machine suits steady full load. For clean processes, an oil free unit or proper filtration is required.

Common Mistakes to Avoid

  • Sizing a compressor from the motor nameplate instead of measured flow.
  • Ignoring air quality and allowing water or oil into the system.
  • Skipping preventive maintenance and waiting for a breakdown.
  • Choosing the lowest price without comparing lifecycle energy cost.

Maintenance and Reliability

A routine service plan keeps output stable and protects the airend, motor and controls. Drain condensate, change filters on schedule, check belts and couplings, and inspect for leaks. A well maintained compressor holds its efficiency and avoids costly unplanned stops.

Next Steps

For help selecting or sizing a system, review the Air Treatment and Screw Air Compressor, or contact AeroWolf with your flow, pressure and air quality requirements.

A clear specification avoids expensive rework. Document the air quality class, the peak and average flow, the pressure band, the power supply and the expected operating hours before asking for a quote.

Compressed air is one of the most common utilities in a factory, yet it is often the least audited. A pressure of 0.1 bar above the requirement already adds measurable energy cost across a full year of operation.

Leakage is a hidden cost. Even a small leak wastes air around the clock. A regular walk through inspection with an ultrasonic detector finds leaks early and pays for itself quickly.

Ambient conditions change the output of a compressor. High intake temperature, high altitude and poor ventilation reduce flow, so the installation room should be cool, clean and well ventilated.

WhatsApp Email Phone