Overview
There are different reasons cause this problem, Check out the correct cause and solve it in time to make sure the normal and long-term operation of the air compressor Q1. Excessive injection of oil leads to high oil level R: Firstly, unload the compressor pressure, then adjust the oil to the normal position Q2. Blockage of oil return pipe R:
Key Details
check and replace the new one Q3. The position of oil return pipe is incorrect R: readjust to correct position Q4. The pressure of the compressor is too low, and the pressure of the air tank is always on the high level Q5. The internal part of the oil air separator is damaged. R: remove oil air separator and inspect the inside Q6. Oil deterioration or overuse R: Replace the oil Q7. The oil return check valve is out of control, which will cause the oil to flow back to the oil air R: separator after the compressor is stopped,
Practical Points
and there will be oil when the compressor restart Q8. Oil air separator damage or over maintenance time R: check and replace the new one
What This Means for Buyers
Energy cost is usually the largest share of a compressor total cost of ownership. In many industrial plants, electricity represents 70 to 80 percent of lifecycle expense. Choosing an energy efficient machine and controlling leaks can cut this cost substantially over a five to ten year operating life. Operators should record pressure, temperature and running hours daily. A small change in these readings often signals an issue before a failure occurs, which is cheaper to fix than an emergency repair.
How to Select the Right Equipment
Start with the actual air demand. Record the required flow, working pressure, voltage, ambient conditions and duty cycle, then add a safety margin. Match the compressor type to the application. A variable speed drive machine suits changing demand, while a fixed speed machine suits steady full load. For clean processes, an oil free unit or proper filtration is required.
Common Mistakes to Avoid
- Sizing a compressor from the motor nameplate instead of measured flow.
- Ignoring air quality and allowing water or oil into the system.
- Skipping preventive maintenance and waiting for a breakdown.
- Choosing the lowest price without comparing lifecycle energy cost.
Maintenance and Reliability
A routine service plan keeps output stable and protects the airend, motor and controls. Drain condensate, change filters on schedule, check belts and couplings, and inspect for leaks. A well maintained compressor holds its efficiency and avoids costly unplanned stops.
Next Steps
For help selecting or sizing a system, review the Air Treatment and Screw Air Compressor, or contact AeroWolf with your flow, pressure and air quality requirements.
A clear specification avoids expensive rework. Document the air quality class, the peak and average flow, the pressure band, the power supply and the expected operating hours before asking for a quote.
Compressed air is one of the most common utilities in a factory, yet it is often the least audited. A pressure of 0.1 bar above the requirement already adds measurable energy cost across a full year of operation.
Leakage is a hidden cost. Even a small leak wastes air around the clock. A regular walk through inspection with an ultrasonic detector finds leaks early and pays for itself quickly.
Ambient conditions change the output of a compressor. High intake temperature, high altitude and poor ventilation reduce flow, so the installation room should be cool, clean and well ventilated.
Downstream equipment benefits from stable pressure. A correctly sized receiver tank and good piping reduce pressure fluctuations and help the compressor run in a steady, efficient range.