Overview
The blowing theory is to use a pusher to push the Optical Fiber Cable(OFC)/ Power Cable into the HDPE duct, in the meanwhile the air compressor supply enough compressed air with high pressure, this kind of high speed compressed air will give the cable a force of moving forward, in this case, the cable is being pushed into the duct
Key Details
instead of pulled. The cable in the duct has been blew smoothly and following the direction of the duct laying. Due to the head of the cable is loosed compared with pulling, there is no force on the head of the cable, after blowing, the cable will stay loosely at the bottom inside the duct, this method is much more helpful for extending the life time of the cable compared with pulling technology. Working pressure:12bar air delivery:10m3/min Step 1:Check the integrity of the pipelines, should be pressurized to check for leaks Step 2:Ready to install fiber optic cable, at the
Practical Points
end of the cable attached traction bullet Step 3:Lubrication piping.Clean the pipe and make full pipeline lubrication Step 4:Start to Blow. Compressed air pushes bullet forward, the bullet carries cable ahead and goes through the pipeline. Nowadays,there are more and more high pressure air compressor used in blowing industry .
What This Means for Buyers
Compressed air systems must be sized for the real air demand, not the maximum connected load. Oversizing wastes energy, while undersizing causes pressure drops and short cycling. A proper audit looks at flow in cubic meters per minute, working pressure in bar, duty cycle, ambient temperature and air quality class. Operators should record pressure, temperature and running hours daily. A small change in these readings often signals an issue before a failure occurs, which is cheaper to fix than an emergency repair.
How to Select the Right Equipment
Start with the actual air demand. Record the required flow, working pressure, voltage, ambient conditions and duty cycle, then add a safety margin. Match the compressor type to the application. A variable speed drive machine suits changing demand, while a fixed speed machine suits steady full load. For clean processes, an oil free unit or proper filtration is required.
Common Mistakes to Avoid
- Sizing a compressor from the motor nameplate instead of measured flow.
- Ignoring air quality and allowing water or oil into the system.
- Skipping preventive maintenance and waiting for a breakdown.
- Choosing the lowest price without comparing lifecycle energy cost.
Maintenance and Reliability
A routine service plan keeps output stable and protects the airend, motor and controls. Drain condensate, change filters on schedule, check belts and couplings, and inspect for leaks. A well maintained compressor holds its efficiency and avoids costly unplanned stops.
Next Steps
For help selecting or sizing a system, review the Screw Air Compressor and Compressed Air Solutions, or contact AeroWolf with your flow, pressure and air quality requirements.
A clear specification avoids expensive rework. Document the air quality class, the peak and average flow, the pressure band, the power supply and the expected operating hours before asking for a quote.
Compressed air is one of the most common utilities in a factory, yet it is often the least audited. A pressure of 0.1 bar above the requirement already adds measurable energy cost across a full year of operation.
Leakage is a hidden cost. Even a small leak wastes air around the clock. A regular walk through inspection with an ultrasonic detector finds leaks early and pays for itself quickly.
Ambient conditions change the output of a compressor. High intake temperature, high altitude and poor ventilation reduce flow, so the installation room should be cool, clean and well ventilated.