Overview
This guide covers Air Compressor and the key points to consider before choosing equipment. What influence the bad quality oil filter will bring for you Today AeroWolf tell you some influences which will come out if you use a bad quality oil filter. 1, Permeation problem at the bottom of the oil filter When the steel material is not good or there is a problem with stretch forming, water, impurities, etc. will precipitate at
Key Details
the bottom, which will easily lead to corrosion and perforation at the bottom of the oil filter. The shell will be burst when it is subjected to pressure. 2, Sealing ring leakage The material of the seal ring, the seal ring is resistant to poor high and low temperature output performance, and the compression deformation rate is poor. After the oil filter is used for a period of time, the seal ring will crack or decrease in elasticity, leading to oil leakage or oil leakage at the seal ring. 3, Sealing edge leaks 1). The lap ratio of the sealing
Practical Points
edge is low, and the sealing plate does not match the size of the housing. 2). If the bypass valve fails or the throughput is small, the throughput of the bypass valve is 1-1.5 times the nominal opening pressure, and the throughput is not less than the rated flow. 4, Filter paper is easy to break The filter paper is easy to break, and many people say that when some of the built-in oil filters are turned on, the filter paper is seen to be broken. In fact, the filter paper has poor carbonization resistance. After prolonged exposure to relatively high temperature and high pressure, it is easily carbonized, and the filter paper is easily broken after carbonization. External oil filter also faces this problem, but the external oil filter is because the filter paper inside the shell, we can not see whether the filter paper inside has been carbonized. The filter paper is easily broken after carbonization, and after
What This Means for Buyers
Compressed air systems must be sized for the real air demand, not the maximum connected load. Oversizing wastes energy, while undersizing causes pressure drops and short cycling. A proper audit looks at flow in cubic meters per minute, working pressure in bar, duty cycle, ambient temperature and air quality class. Operators should record pressure, temperature and running hours daily. A small change in these readings often signals an issue before a failure occurs, which is cheaper to fix than an emergency repair.
How to Select the Right Equipment
Start with the actual air demand. Record the required flow, working pressure, voltage, ambient conditions and duty cycle, then add a safety margin. Match the compressor type to the application. A variable speed drive machine suits changing demand, while a fixed speed machine suits steady full load. For clean processes, an oil free unit or proper filtration is required.
Common Mistakes to Avoid
- Sizing a compressor from the motor nameplate instead of measured flow.
- Ignoring air quality and allowing water or oil into the system.
- Skipping preventive maintenance and waiting for a breakdown.
- Choosing the lowest price without comparing lifecycle energy cost.
Maintenance and Reliability
A routine service plan keeps output stable and protects the airend, motor and controls. Drain condensate, change filters on schedule, check belts and couplings, and inspect for leaks. A well maintained compressor holds its efficiency and avoids costly unplanned stops.
Next Steps
For help selecting or sizing a system, review the Air Treatment and Compressed Air Solutions, or contact AeroWolf with your flow, pressure and air quality requirements.